Setting up the monitor │ 21
Setting up the monitor
Connecting the stand
NOTE: The stand is detached when the monitor is shipped from the
factory.
NOTE: The following procedure is applicable for the stand that shipped
with your monitor. If you are connecting a third-party stand, see the
documentation that shipped with the stand.
To attach the monitor stand:
1. Follow the instructions on the flaps of packaging box to remove the stand from
the top cushion that secures it.
2. Connect the stand base to the stand riser.
3. Open the screw handle on the stand base and tighten the screw to secure the
stand riser to the stand base.
4. Close the screw handle.
To Next Page
Loading...
