10. See the documentation that came with the drive for instructions on installing any software required for drive operation.
11. Check the System Setup for drive configuration changes (see System Setup).
Media Card Reader
Removing the Media Card Reader
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. Remove the front bezel (see Removing the Front Bezel).
4. Remove the optical drive (see Removing the Optical Drive).
5. Remove the top cover (see Removing the Top Cover).
6. Remove the two screws that secure the Media Card Reader to the front panel. The screws are located below the Media Card Reader.
7. Disconnect the Media Card Reader cable from the system board connector (see System Board Components).
8. Slide and remove the Media Card Reader from the computer as shown in the illustration.
Replacing the Media Card Reader
1. Follow the procedures in Before You Begin.
2. Gently slide the Media Card Reader guides into the slots in the top panel.
3. Replace the two screws that secure the Media Card Reader to the front panel.
4. Connect the Media Card Reader cable to the system board connector (see System Board Components).
To Next Page
Loading...
