Dell Studio XPS 9100 - Badge Back-Light Module; Removing the Badge Back-Light Module; Replacing the Badge Back-Light Module

Back to Contents Page
 Badge Back-Light Module
Dell™StudioXPS™9100ServiceManual
Removing the Badge Back-Light Module
Replacing the Badge Back-Light Module

Removing the Badge Back-Light Module

1. Follow the instructions in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the front bezel (see Removing the Front Bezel).

4. Remove the two screws that secure the hinge to the front bezel.

5. Pull the hinge away from the front bezel.

6. Remove the badge back-light cable from the securing tabs.

7. Press the tabs away from the badge back-light module and pull the badge back-light module away from the front bezel.
Replacing the Badge Back-Light Module

1. Follow the instructions in Before You Begin.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
badge back-light module
2
tabs (3)
3
badge back-light cable
4
screws (2)
5
hinge