Dell Vostro 1320 - Display Assembly; Removing the Display Assembly

Back to Contents Page
Display Assembly
Dell™Vostro™1320ServiceManual
Removing the Display Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the hard drive from the computer.
4. Remove the WLAN card from the computer.
5. Remove the hinge cover from the computer.
6. Remove the keyboard from the computer.
7. Disconnect the antenna cables from the WLAN card.
8. Draw the antenna cables through the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.