Dell Vostro 1320 - Palm Rest; Removing the Palm Rest

Back to Contents Page
Palm Rest
Dell™Vostro™1320ServiceManual
Removing the Palm Rest
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the access panel from the computer.
4. Remove the heat sink from the computer.
5. Remove the hinge cover from the computer.
6. Remove the hard drive from the computer.
7. Remove the optical drive from the computer.
8. Remove the display assembly from the computer.
9. Remove the thirteen screws that secure the palm rest to the bottom of the computer.
10. Turn over the computer and release the fingerprint reader data cable clip.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.