Dell Vostro 3250 - Installing the Heat Sink Assembly; Removing the Memory

Figure 10.
Installing the heat sink assembly
1. Place the heat sink assembly in the slot by aligning with the screw holders.
2. Tighten the screws to secure the heat sink assembly to the system board.
3. Connect the heat sink assembly cable to the system board.
4. Install:
a. heat sink fan cover
b. optical drive
c. hard drive assembly
d. front bezel
e. cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the memory
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Pry the securing clips away from the memory module until it pops up. Remove the memory module
from its socket on the system board.
14