4. Follow the steps to remove the I/O panel:
a. Remove the screw that secures the I/O panel to the computer.
b. Slide the I/O panel outwards and remove it from the computer.
Installing the Input/Output (I/O) Panel
1. Slide the I/O panel into its slot on the computer.
2. Replace the screw that secures the I/O panel.
3. Route the cables through the metal clips.
4. Connect the I/O panel and FlyWire cables to the system board.
5. Install the:
• bezel
• cover
6. Follow the procedures in After Working Inside Your Computer.
20
To Next Page
Loading...
