Steps
1. In reverse sequential order (7>6>5>4>3>2>1), loosen the seven captive screws that secure the heat sink to the system
board.
2. Lift the heat sink off the system board.
Installing the heat sink for computers shipped with a NVIDIA
GeForce RTX 2050 Ti graphics card
Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Removing and installing components
27
To Next Page
Loading...
