42 Chapter 4
necessary, for authentication). Validate Server Certificate is optional. Also note
that the server certificate text field supports a maximum of approximately 127
characters, and supports multiple server names.
The following kinds of server names are supported (all examples are based on
Cert Common name is "company.wyse.com"). NOTE: Using only the FQDN, i.e.
company.wyse.com will not work, you must use one of the options (note that
*.wyse.com is the most common option as multiple authentication servers may
exist):
servername.wyse.com
*.wyse.com
*wyse.com
*.com
*
To configure EAP-GTC, enter the username only, and the password or PIN will be
asked when authenticating. To configure EAP-MSCHAPv2, enter the username,
password, and domain (domain/username in the username box is supported, but
you must leave the domain box blank). Note that the CA certificate must be
installed on the thin client (the server certificate is forced to be validated). Also
note that when EAP Type EAP-MSCCHAPV2 is selected on the Authentication
Properties dialog box (for PEEP IEEE802.1x authentication), an option to hide the
domain is available for selection (the Username and Password text boxes are
available for use, but the Domain text box displays gray).
• Certificate Management - Opens the Certificates Browser where you can select
the Import From option you want to import a certificate (either USB Storage or File
Server).
USB Storage - If you select the USB Storage option, click Import to open and use
the Import dialog box to find and select the certificate you want to use. The
maximum importing path is limited to 128 characters and the maximum certificate
name is limited to 64 characters.
File Server - If you select the File Server option, click Import to open and use the
Import dialog box to enter the detailed path to the certificate you want to use in the
File Servers box (if necessary, be sure to use the correct Username and Password).
Note that you must enter the absolute path of the certificate. For example:
10.151.121.100/wnos/cacerts/mycertificate.cer. The maximum importing path is
limited to 128 characters and the maximum certificate name is limited to 64
characters.
Use the Wireless tab to view the Connected SSID, Connection Speed, Signal Strength,
add (click Add and enter your configurations), remove (select an SSID and click
Remove), check properties (select an SSID and click Property), move SSIDs up and
down in the priority list (select an SSID and click Up or Down) and to scan and list the
wireless networks within range (click Scan—NOTE: the SSID, State, Type, and Signal of
each wireless network will be detected and displayed in a Wireless Connections
window).
To Next Page
Loading...
