A Central Configuration: Automating
Updates and Configurations
This appendix describes how to set up your environment to provide your thin clients
running ThinOS with automatic updates and configurations in three simple steps.
TIP: Wyse thin clients do not require device management software. They are
configured to obtain their IP address, as well as the location of firmware and
configuration instructions, from a DHCP server. However, you can use WDM for a more
hands-on management of your thin clients. For information about configuring your
thin clients to communicate with a WDM server, see the WDM related INI parameters in
"Step 2: Direct the Thin Client to the Server Using DHCP Options" and Reference Guide:
Wyse ThinOS
TM
INI Files.
To Next Page
Loading...
