Dell XPS 12 - Replacing the Base Cover; Base Cover Replacement Procedure

12 | Replacing the Base Cover
Replacing the Base Cover
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 9. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Slide the power-switch slot into the power switch, and place the base cover on the
palm-rest assembly.
2 Snap the base cover into place.
3 Replace the screws that secure the base cover to the palm-rest assembly.
4 Turn the system badge over and snap it into place.
5 Follow the instructions in "After Working Inside Your Computer" on page 9.
book.book Page 12 Tuesday, October 23, 2012 12:44 AM