Dell XPS 12 - Replacing the Display Assembly; Display Assembly Replacement Procedure

46 | Replacing the Display Assembly
Replacing the Display Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 9. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Slide the tabs on the palm-rest assembly into the slots on the display hinges.
2 Replace the screws that secure the display assembly to the palm-rest assembly.
3 Connect the antenna cables to the wireless mini-card.
4 Connect the power-adapter port cable and display cables to the system board.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 14.
2 Replace the base cover. See "Replacing the Base Cover" on page 12.
3 Follow the instructions in "After Working Inside Your Computer" on page 9.
book.book Page 46 Tuesday, October 23, 2012 12:44 AM