4. Remove the four screws (M1.6x2.3) that secure the two display-assembly cable brackets to the palm-rest and keyboard
assembly.
5. Lift the display-assembly cable brackets off the system board.
6. Remove the six screws (M2.5x4.3) that secure the hinges of the display assembly to the palm-rest and keyboard assembly.
7. Remove the screw (M1.6x3) and the screw (M1.6x2.5) that secure the left hinge of display assembly to the system board
and the palm-rest and keyboard assembly.
8. Remove the screw (M1.6x3) and the screw (M1.6x2.5) that secure the right hinge of display assembly to the I/O daughter-
board and the palm-rest and keyboard assembly.
9. Lift the display assembly off the palm-rest and keyboard assembly.
10. After performing all the above steps, you are left with display assembly.
Results
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing components
25
To Next Page
Loading...
