16 Power-Light Board
Replacing the Power-Light Board
1
Align the screw hole on the power-light board with the screw hole on
the palm-rest assembly.
2
Replace the screw that secures the power-light board to the
palm-rest assembly.
3
Slide the power-light board cable into the system-board connector
and press down on the connector latch to secure the cable.
Postrequisites
1
Replace the base cover. See "Replacing the Base Cover" on page 14.
2
Follow the instructions in "After Working Inside Your Computer" on page 11.
OM_Book.book Page 16 Tuesday, September 25, 2012 2:30 PM
To Next Page
Loading...
