64 Palm-Rest Assembly
Removing the Palm-Rest Assembly
1
Remove the screws that secure the display assembly to the
palm-rest assembly.
2
Gently lift the palm-rest assembly to a 90-degree angle and then release
the palm-rest assembly off the display assembly.
CAUTION: Carefully separate the palm-rest assembly from the display assembly
to avoid damage to the display assembly.
Replacing the Palm-Rest Assembly
1
Slide and place the palm-rest assembly over the display assembly.
2
Press down on the display hinges and ensure the screw holes in the display
hinges align with the screw holes on the palm-rest assembly.
3
Replace the screws that secure the palm-rest assembly to the display assembly.
1 palm-rest assembly 2 screws (4)
3 display hinges (2)
OM_Book.book Page 64 Tuesday, September 25, 2012 2:30 PM
To Next Page
Loading...
