Steps
1. Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface.
2. Place the palm-rest and keyboard assembly at the edge of a flat table.
3. Open the hinges of the display assembly to a 90-degree angle.
4. Align the screw holes of the palm-rest and keyboard assembly to the screws holes on the hinges of the display assembly.
5. Replace the three screws (M2.5x5) that secure the left hinge to the palm-rest and keyboard assembly.
6. Replace the three screws (M2.5x5) that secure the right hinge to the palm-rest and keyboard assembly.
7. Close the display assembly, turn the computer over and place it on the flat surface.
8. Slide the camera and display-assembly cables holder back to the system board.
9. Replace three screws (M1.6x2.5) that secure the camera and display-assembly cables holder to the system board.
10. Connect the camera cable and the display cable to the system board.
32
Removing and installing components
To Next Page
Loading...
