Dell XPS 13 Plus 9320 - System Board; Removing the System Board

11. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board and tighten the three
captive screws (M1.6x2).
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive from M.2 slot, whichever applicable.
4. Remove the battery.
5. Remove the fans.
6. Remove the heat sink.
About this task
The following image indicates the connectors and component(s) on your system board.
Figure 1. System-board connectors
1.
Wireless card 2. Camera-assembly cable connector
3. Display-assembly cable connector 4. Capacitive touch-panel cable connector
5. Left-speaker cable connector 6. Left-fan cable connector
7. Haptic-module cable connector 8. M.2 solid-state drive slot
9. Battery cable connector 10. Keyboard-daughterboard cable connector
11. Right-fan cable connector 12. Right-speaker cable connector
13. Power-button and fingerprint-reader cable connector
The following image(s) indicate the location of the system board and provides a visual representation of the removal procedure.
Removing and installing components
33