6. Connect the keyboard cable and close the latch of the keyboard connector.
Next steps
1. Install the power button with fingerprint reader.
2. Install the system board.
NOTE: The system board can be replaced with the following components attached:
● heat sink
● fans
● solid-state drive
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the system board.
NOTE:
The system board can be removed with the following components attached:
● heat sink
● fans
● solid-state drive
5. Remove the power button with fingerprint reader.
6. Remove the keyboard.
About this task
The following image(s) indicate the location of the palm-rest assembly and provides a visual representation of the removal
procedure.
44
Removing and installing components
To Next Page
Loading...
