Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the connectors and component(s) on your system board.
Figure 2. System-board connectors
1.
Wireless card 2. Camera-assembly cable connector
3. Display-assembly cable connector 4. Capacitive touch-panel cable connector
5. Left-speaker cable connector 6. Left-fan cable connector
7. Haptic-module cable connector 8. M.2 solid-state drive slot
9. Battery cable connector 10. Keyboard-daughterboard cable connector
11. Right-fan cable connector 12. Right-speaker cable connector
13. Power-button and fingerprint-reader cable connector
The following image(s) indicate the location of the system board and provides a visual representation of the installation
procedure.
36
Removing and installing components
To Next Page
Loading...
