Steps
1. Align the notch on the solid-state drive 2 with the tab on the solid-state drive slot.
2. Gently slide the solid-state drive 2 into the solid-state drive slot.
3. Slide the solid-state drive thermal bracket into the peg on the system board, and align the screw hole on the solid-state drive
thermal bracket with the screw hole on the system board.
NOTE: The thermal bracket for SSD slot 1 is labelled “SSD-L”, while the thermal bracket for SSD slot 2 is labelled
“SSD-R”.
4. Replace the screw (M2x2) that secures the solid-state drive thermal bracket and the solid-state drive 2 to the system
board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Fans
Removing the left fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the left fan and provide a visual representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
