Steps
1. Peel the tape that secures the left-fan cable to the system board.
2. Disconnect the left-fan cable from the system board.
3. Remove the two screws (M2x4) that secure the left fan to the system board and palm-rest and keyboard assembly.
CAUTION: Do not hold the fan assembly at the center, as it may damage the center bearing.
4. Lift the right side of the left fan slightly. Then, slide the left fan to the right to remove it from the palm-rest and keyboard
assembly.
Installing the left fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the left fan and provide a visual representation of the installation procedure.
26
Removing and installing components
To Next Page
Loading...
