11. Remove the I/O board.
12. Remove the display assembly.
13. Remove the system board.
About this task
After performing all the pre-requisites, you are left with the palm-rest and keyboard assembly.
NOTE: The antennas and their cables are part of the palm rest assembly and must not be removed from the system.
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation
procedure.
Removing and installing components
51
To Next Page
Loading...
