Steps
1. Connect the left-fan cable to the system board.
2. Slide fan below the heat sink and align the screw holes on the left fan with the screw holes on the system board and
palm-rest and keyboard assembly.
3. Replace the two screws (M2x4) that secure the left fan to the system board and palm-rest and keyboard assembly.
4. Adhere the tape that secures the left-fan cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the right fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the right fan and provide a visual representation of the removal procedure.
Removing and installing components
27
To Next Page
Loading...
