Dell XPS 210 - Removing Memory


5. Replace the computer cover (see Replacing the Computer Cover).

6. Connect your computer and devices to electrical outlets, and then turn them on.

7. When a message appears stating that memory size has changed, press <F1> to continue.

8. Log on to your computer.

9. Right-click the My Computer icon, then click Properties.

10. Click the General tab.

11. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory


1. Follow the procedures in Before You Begin.

2. Press out the securing clip at each end of the memory module connector.

3. Grasp the module and pull up.
If the module is difficult to remove, ease the module back and forth to remove it from the connector.
Cards

YourDell™computerprovidesthefollowingslotsforPCIExpresscards:
l One PCI Express x16 card slot
l One PCI Express x1 card slot
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE: The slots for the PCI Express x16 and PCI Express x1 cards are half-height slots.