Removing a PCI Express Card
1. Follow the procedures in Before You Begin.
2. Gently push the release tab on the card retention door from the inside to pivot the door open. Because the door is attached, it will remain in the open
position.
3. Gently pull back the securing tab, grasp the card by its top corners, and then ease it out of its connector.
If necessary, disconnect any cables connected to the card.
4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell.
5. Before you close the card retention door, ensure that:
l The tops of all cards and filler brackets are flush with the alignment bar.
l The notch in the top of the card or filler bracket fits around the alignment guide.
6. Close the card retention door by snapping it into place to secure the cards.
7. Replace the computer cover (see Replacing the Computer Cover).
8. Connect the computer and devices to electrical outlets, and then turn them on.
9. Uninstall the driver for that card.
Hard Drive
Removing a Hard Drive
1. Follow the procedures in Before You Begin.
2. Press in on the blue tabs on each side of the drive, then slide the drive up and out of the computer.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.