Dell XPS 210 - Replacing the Computer Cover

Back to Contents Page
 Replacing the Computer Cover
Dell™XPS™210ServiceManual


1. Ensure that all cables are connected and folded out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.

2. Ensure that no tools or extra parts are left inside the computer.

3. Install the cover:
a. Align the bottom of the cover with the tabs located along the bottom of edge of the computer.
b. Using the tabs as leverage, rotate the cover downward.
c. Press down on the right side of the cover until it closes.
d. Press down on the left side of the cover until it closes.
e. Ensure that both sides of the cover are locked before moving the computer to the upright position.

4. Connect your computer and devices to electrical outlets, and then turn them on.
Back to Contents Page

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the computer.