10  |  Before You Begin
Safety Instructions
Use the following safety guidelines to protect your computer from potential damage and 
ensure your personal safety.
  WARNING:  Before working inside your computer, read the safety information 
that shipped with your computer. For additional safety best practices 
information, see the Regulatory Compliance Homepage at  
dell.com/regulatory_compliance.
  WARNING:  Disconnect all power sources before opening the computer cover or 
panels. After you finish working inside the computer, replace all covers, panels, 
and screws before connecting to the power source.
  CAUTION: To avoid damaging the computer, ensure that the work surface is flat 
and clean.
  CAUTION: To avoid damaging the components and cards, handle them by their 
edges and avoid touching pins and contacts.
  CAUTION: Only a certified service technician is authorized to remove the 
computer cover and access any of the components inside the computer.  
See the safety instructions for complete information about safety precautions, 
working inside your computer, and protecting against electrostatic discharge.
  CAUTION: Before touching anything inside your computer, ground yourself by 
touching an unpainted metal surface, such as the metal at the back of the 
computer. While you work, periodically touch an unpainted metal surface to 
dissipate static electricity, which could harm internal components.
  CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, 
not on the cable itself. Some cables have connectors with locking tabs or 
thumb-screws that you must disengage before disconnecting the cable.  
When disconnecting cables, keep them evenly aligned to avoid bending any 
connector pins. When connecting cables, ensure that the connectors and ports 
are correctly oriented and aligned.
  CAUTION: To disconnect a network cable, first unplug the cable from your 
computer and then unplug the cable from the network device.
  CAUTION: Press and eject any installed card from the media-card reader.
Recommended Tools
The procedures in this document may require the following tools:
• Phillips screwdriver
• Plastic scribe
OM_Book.book  Page 10  Tuesday, April 30, 2013  6:07 PM