EasyManua.ls Logo

Dell XPS M1330 - Replacing a WWAN Card; Flash Cache Module; Removing the FCM

Dell XPS M1330
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Communication Cards: Dell XPS M1330 Service Manual
file:///C|/Users/SIIES/Downloads/Dell XPS 1330/minicard.htm#wp1180188[16/07/2010 06:26:58 p.m.]
Replacing a WWAN Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card
and on the system board, and realign the card.
NOTICE: To avoid damage to the WWAN card, never place cables under the card.
1. Insert the WWAN card connector at a 45-degree angle into the system board connector labeled "WWAN."
2. Press the other end of the WWAN card down into the slot on the system board until the card clicks into place.
3. Replace the M2 x 3-mm securing screw.
4. Connect the black antenna cable with a gray stripe to the connector labeled "aux" (black triangle), and connect the
white antenna cable with a gray stripe to the connector labeled "main" (white triangle).
5. Secure unused antenna cables in the protective mylar sleeve.
6. Replace the cover and tighten the captive screws.
Flash Cache Module
The FCM, or Flash Cache Module, is an internal memory card that helps improve the performance of your computer. The FCM
card is also known as Intel Turbo Memory and the Intel® Flash Cache Logic Chip Mini-card.
NOTE: This card is only compatible with the Microsoft Windows Vista™ operating system.
If you ordered an FCM card with your computer, the card is already installed.
Removing the FCM
1. Follow the procedures in Before You Begin.
2. Turn the computer over and remove the cover on the Mini Card compartment.

Table of Contents

Other manuals for Dell XPS M1330

Related product manuals