Regulating the temperature
The right fig shows the thermostat. Turn the knob clockwise to get lower temperature inside.
It will take several hours for the refrigerator to reach normal operating temperature.
Please note that too much lower temperature might make vegetables or eggs frozen.
DC power is not regulated by this thermostat.
Turning off the refrigerator
If the refrigerator is not to be used for a period:
1. Shut off any valve in the gas line to the refrigerator.
2. Empty the refrigerator. Defrost and clean it. It must be completely dry inside to avoid mold growth.
3. Pull out the hook as figs below and secure it to the hole underneath the front cover. This will allow the door to be
open slightly always and get air circulated.
Winter Operation
If the ambient temperature is lower than 10 degrees, the winter cover should be fitted. This will protect the cooling unit
from excessively cold air which might result in too much strong or even poor performance of the unit.
Insert Decor Panel
The doors are designed to accept decorative door panels to match the kitchen décor. The decorative panels must be
4 mm or less in thickness. Door panels should be installed in the refrigerator doors before installing the refrigerator in
the vehicle. The door panel dimensions for XCD-90B are 19.1" (485±0.5mm) wide by 26.3" (670±0.5mm) high.
To install the door panels, first pull the panel retainer off the bottom of the door by removing two screws. Push the
door panel into the slots of the door and put the panel retainer back into place to hold the panel inside the door. See
Fig below.
10
To Next Page
Loading...