DeLonghi DFG 903 - How to Use the Gas Oven

11
How to use the gas oven
Lighting the oven gas burner
The thermostat allows the automatic control of the temperature.
The gas delivery to the oven burner is controlled by a two way thermostatic tap (oven
and grill burners) with flame-failure device.
To light the oven burner operate as follow:
1) Open the oven door
2) Lightly press and turn the thermostat knob anti-clockwise to max position “ ”.
3) Press the knob right down to prime the electric ignition.
WARNING: Risk of explosion! The oven door must be open during this operation.
In case of power cut, press the knob and immediately approach a lighted match to the
opening “A” (fig. 8). Never continue this operation for more than 15 seconds. If the
burner has still not ignited, wait for about 1 minute prior to repeating the ignition.
4) Wait about 10/15 seconds after the burner lighting before releasing the knob (time of priming
of the valve).
5) Close the oven door slowly and adjust the burner
according to the power required.
Should the flame of the burner estinguish
for any reason, the safety valve will cut off
automatically the gas flow to the tap.
To re-start operation, take the knob to “off”
position, wait for at least 1 minute and
repeat operations as above explained.
Oven thermostat
The oven thermostat (fig. 9) is marked with
numbers, these correspond to the oven
temperature, in addition the “OFF” position is
shown by the
symbol ●.
To choose the
required oven
temperature (check
with the “Oven
cooking
temperatures”), turn
the control knob until
its line mark is level
with the number
required on the
control panel (facia).
Fig. 8
A
Fig. 9