13
Figure 12
USING THE OVEN FOR THE FIRST TIME
(models with electronic programmer only)
■ Assemble the sliding shelves on the oven walls using the 2 screws and inter-
posing the catalytic panels A and B with the arrow up (fig. 11). The catalytic
panel A with the hole for the side oven lamp must be positioned on the left
oven wall. DO NOT INTERPOSE THE CATALYTIC PANEL B ON THE LEFT
OVEN WALL.
■ Slide in the grease filter on the back of the oven as in Fig. 17.
■ Position the shelf and tray on the sliding shelves (fig. 13).
■ To eliminate traces of grease in manufacture it is necessary to pre-heat the oven
at the maximum temperature:
• For 60 minutes in the position, for 30 minutes in the position and for
another 15 minutes in the position.
■ Slide off the sliding shelves and the catalytic panels to the oven walls as in
Fig. 11. The grill is secured to the rear wall of the oven on a hinge system
that allows it to be lowered to allow proper access when cleaning the oven
ceiling (fig. 12).
■ Clean the inside of the oven with a cloth soaked in water and neutral detergent
and dry thoroughly.
Figure 13
To Next Page
Loading...
