30
REPLACING THE OVEN LAMP
WARNING: Ensure the appliance is switched off before replacing the lamp to
avoid the possibility of electric shock.
■ Let the oven cavity and the heating elements to cool down;
■ Switch off the electrical supply;
LEFT LAMP
(models with electronic progra
mmer only)
:
■ Remove the left sliding shelf and the side catalytic panel by unscrewing the fix-
ing screws (see chapter USING THE OVEN FOR THE FIRST TIME at page 13).
■ Press down from the top the protective cover A (fig. 28) and remove it by rotat-
ing on the lower side. IMPORTANT: never use screwdrivers or other utensils to
remove the cover A. This could damage the enamel of the oven or the lam-
pholder. Operate only by hands.
■ Unscrew and replace the bulb B with a new one suitable for high temperatures
(300°C) having the following specifications: 230-240V 50 Hz, 25W, E14.
■ Refit the protective cover A operating in reverse order. ATTENTION: the notch
in the inner edge of the cover must be oriented toward the lamp.
■ Assemble the side catalytic panel and the left sliding shelf.
TOP RIGHT LAMP (all models):
■ Remove the protective cover C (fig. 28);
■ Unscrew and replace the bulb B with a new one suitable for high temperatures
(300°C) having the following specifications: 230-240 V 50 Hz, (15 W for models
with cut-off timer and 25 W for models with electronic programmer), E14
■ Refit the protective cover;
NOTE: Oven bulb replacement is not covered by your guarantee.
To Next Page
Loading...
