DeLonghi DMFPS60BF - Reassembling the Inner Glass; Correct Inner Glass Placement

32
D
A
Figure 39
G
Figure 38
Figure 34
REASSEMBLING THE INNER GLASS
To reassemble the inner glass of the
oven door operate as follows:
– Check the correct positioning of the
no. 4 (four) silicon rubbers “D” (fig.
34).
- Insert the inner glass in the left “E”
and right “F” side guides (fig. 35) and
gently let it slide up to the retainers
“H” (fig. 36).
- Reassemble the seal “G” in the correct
way (fig. 37) by hooking the no. 3
(three) fixing hooks in the proper
holes (fig. 38).
- Open completely the oven door and
close the lever “A” on the left and
right hinges (fig. 39).
VERY IMPORTANT NOTE: The inner
glass has only one thermo-reflecting
side. When correctly placed you should
correctly read the wording printed on
it (at the top or at the bottom).
E
F
Figure 37
H
Figure 36
It is normal the opened gap between the top
edge of the inner glass and the sealed gasket.
This allows the cooling air circulation.
Figure 35