location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 10°C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
free space requirements
When installing the unit, ensure that 25 mm of free
space is left at both sides, 50 mm at the rear of the
unit and 25 mm at the top of the unit.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the doors to a maximum angle.
installing the water filter
• Choose a wall area with distance that is near the water tap and the unit.
• Do not install the water filter behind the unit, but should install it in an area that is convenient
for it to be replaced.
• To operate properly, connect the unit to the water mains with water pressure of 207~689
Mpa.
Do not install the water filter on the unit body.
14
DSBSDIX17_IB_2L_RC_190708_grace.indb 14 8/7/2019 6:30 PM
To Next Page
Loading...
Need help?
General
