4040
ELECTRONIC CLOCK (g. 7.2)
The programmer is equipped with an
electronic clock with illuminated numbers
which indicates hours and minutes.
Upon immediate connection of the oven or
after a power cut, three zeros will ash on
the programmer display.
To set the correct time of day it is necessary
to push the
button and then the or
button until you have set the correct
time (g. 7.2).
In another way push simultaneously the
two buttons and at the same time
push the or button.
Note: If the clock is reset it deletes any
previously set programs
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the
aid of the programmer, it is necessary to
cancel the ashing AUTO by pushing the
button (AUTO will be switched o and
the symbol
will illuminate - g. 7.3).
Attention: If the AUTO is illuminated (which
means a cooking program has already
been inserted), by pushing the button
you cancel the program and return to
manual operation.
If the oven is switched on, you must switch
o manually.
ELECTRONIC TIMER
The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO symbol is ashing push the
button.
To set the time, push the
button and the
or until you obtain the desired time in
the display (g. 7.4).
Having nished the setting, the clock hour
will appear on the panel and the symbol
will be illuminated.
The countdown will start immediately and
may be seen at any moment on the panel
by simply pressing the button
.
At the end of the time, the symbol will
disappear and the buzzer will sound and
continue for approximatley 7 minutes or
until a button is pressed (not the
/
buttons). After a short time the display will
revert back to the time of day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 dierent tones and can
be changed by pressing the
button, but
only when the time of day is displayed
Fig. 7.4Fig. 7.3
To Next Page
Loading...
Need help?
General
