16
2. Turn the date disk (g. 8) to display the next 2 months of
use;
Please note: The lter lasts about two months if the appliance is used nor-
mally. If the coee machine is left unused with the lter installed, it will last no longer
than 3 weeks.
3. To activate the lter, run tap water through the hole in the
lter (g. 9) until water comes out of the openings at the
side for more than a minute;
4. Extract the tank (A8) (if necessary ll with water);
5. Insert the lter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (g. 10);
6. Place the lter in the lter housing (g. 11) and press as
far as it will go. Close the tank with the lid, then replace the
tank in the machine;
The lter is now active and the coee machine can be used.
5. MENU SETTINGS
To access the menu, make sure the appliance is in stand-by, then
press the (B1) and (B3) buttons together until the
ON/Stand-by light (B2) ashes. The appliance is now in pro-
gramming mode.
Set the coee machine as you wish, then exit the settings menu
by pressing the button.
5.1 Setting the temperature
To change the temperature of the water used to make the cof-
fee, proceed as follows:
1. Access the settings menu;
2. Press the button (B5) and hold it down until the
lights corresponding to the required temperature come on
(see "Temperature and stand-by regulation table" at the
end of the next section);
3. When the lights corresponding to the required selection
come on, release the button;
4. Then press the button to turn the appliance o
(stand-by).
5.2 Adjusting the stand-by interval
If the appliance is not used for a certain period of time (varia-
ble according to the model), it turns o automatically (the ON/
Stand-by light goes out).
Auto-o can be set so that the appliance goes o after a certain
period of time. Proceed as follows:
1. Access the settings menu;
2. Press the button (B3) and hold it down until the
lights corresponding to the required idle period come on
(see table);
3. When the lights corresponding to the required selection
come on, release the button.
4. Then press the button (B1) to turn the appliance o
(stand-by).
Temperature and stand-by regulation table
Temperature Corresponding lights Stand-by after
Low 15 minutes
Medium 75 minutes
High 3 hours
5.3 Setting water hardness
The "descale" lights come on after a period of use established
according to water hardness.
The machine can also be programmed according to the hardness
of the mains water in the various regions so that the machine
needs to be descaled less often. Proceed as follows:
1. Remove the "TOTAL HARDNESS TEST" indicator paper (C8)
from its pack;
2. Immerse the paper completely in a glass of water for one
second;
3. Remove the paper from the water and shake lightly. After
about a minute, 1, 2, 3, or 4 red squares form, depending
on the hardness of the water (4 red squares = very hard
water);
4. Access the settings menu;
5. After reading the result from the strip, press and hold the
"hot water" button (B7) until the lights come on ac-
cording to the following table;
To Next Page
Loading...
Need help?
General
