22
LIGHTS OPERATION EXPLANATION OF LIGHTS
The appliance has been idle for several
minutes or the ON/STAND-BY button has
been pressed.
The appliance is in STAND-BY. To turn it
on again, press the button.
The interval of time before the appliance
switches to Stand-by can be adjusted,
see section "Adjusting the Stand-by
interval".
The tank is empty or the appliance is
unable to make coee.
See the section “17. TROUBLESHOOTING”
PROBLEM POSSIBLE CAUSE SOLUTION
The appliance does not come
on
The power cord (C5) is not inserted
correctly
Make sure the power cord connector is fully
inserted into the socket (A4) on the back of the
appliance, then make sure the plug is correctly
plugged into the mains socket
No espresso coee is delivered No water in the tank (A8) Fill the tank with water
The holes in the lter holder (C1) are
blocked
Clean the lter holder spout holes
The lter and removable perforated lter
are blocked
Clean as described in section “13.4 CLEANING THE
COFFEE FILTERS”
The espresso boiler outlet (A5) is blocked Clean as described in section “13. CLEANING”
Scale in the water circuit Descale as described in section “14. DESCALING”
The espresso coee drips from
the edges of the lter holder
(C1) rather than the holes
The lter holder has been inserted incor-
rectly or is dirty
Attach the lter holder correctly and rotate rmly
as far as it will go
The lter and removable perforated lter
are blocked
Clean as described in section “13.4 CLEANING THE
COFFEE FILTERS”
The espresso boiler gasket has lost elas-
ticity or is dirty
Have the espresso boiler gasket replaced by Cus-
tomer Services
The holes in the lter holder spouts are
blocked
Clean the lter holder spout holes
17. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
To Next Page
Loading...
Need help?
General
