11
18 19
• Insert the burr in its hous-
ing (g. 19);
• Turn the selector to select
the desired grinding level
(g. 20);
• Make sure the burr is in-
serted correctly by pulling
it by the handle. If it is
correctly inserted, it will
not move;
9. Clean the beans container
housing with a damp cloth
and dry;
10. Put the container back (g. 15).
5.9 Replacing the burrs
When the quantity of coee becomes even less, contact a cus-
tomer services centre to have the burrs replaced, then adjust
the mill again as follows entering the setting menu (“3. Menù
settings”) and selecting the rst range of the “Extra grinding
adjustment”.
Then turn the ground coee quantity dial (B2) to minimum posi-
tion and set the dose like a rst use (see Quick Guide).
5.10
Cleaning the “Smart tamping station”
To guarantee top quality grinding, clean the “Smart tamping
station” regularly as follows:
1. Clean the attachment area with a brush (g. 21).
21 22
2. Pull the
lever
(A20) as far
as it will go and clean the
presser cylinder with a
brush (g. 22). Then rele-
ase the lever.
3. Use the tube brush (C9)
to clean the coee funnel
(g. 23).
5.11 Cleaning the LatteCrema System
Clean the milk container each time you prepare milk as de-
scribed below:
1. Push the release button (D3) and lift the milk container lid
(D1) (g. 24);
2. Remove the milk spout (D4) and milk intake tube (D7) (g.
25);
24 25
3. Turn the froth adjustment dial (D5) counter-clockwise to
the “Insert” position (g. 26) and pull;
20
To Next Page
Loading...
Need help?
General
