23
Setting Up the Antenna
Repeater Antenna
The Delphi Premium Sound System comes with a repeater antenna bracket.
This bracket can be attached to base of the unit using the two screws
provided with the bracket. Once the bracket is attached to the audio system,
the repeater antenna can be snapped in place and the wire can be routed
through the opening provided in the rear under the top cover. Plug the
antenna into the connector and secure the access wire to the cover. The top
cover can now be snapped in place.
Once the Delphi Premium Sound System is set up and the satellite receiver
is installed, the complete setup can be controlled as described in the
receiver’s operating guide.
To Next Page
Loading...
Need help?
General
