22
Reference
Troubleshooting
SKYFi2 is designed and built to provide
you with trouble-free performance
without the need for servicing. If it
does not appear to be functioning
properly, follow these troubleshooting
steps:
1. Attach all connections firmly and
securely.
2. Make sure the cigarette
lighter/auxiliary power socket is
clean and free of corrosion.
3. If you have installed SKYFi2 in a
vehicle and it does not power on,
check the 12V adaptor fuse by
unscrewing the ribbed end of the
adaptor. If required, replace with a
If you see this on the display:
NO SIGNAL
Cause: the XM signal is being
blocked.
ANTENNA
Cause: the XM antenna is not
plugged into SKYFi2.
OFF AIR
Cause: the channel selected is
not currently broadcasting.
You should:
Move SKYFi2 and its antenna away from the
obstructed area, e.g. an underground garage. Make
sure the antenna is mounted outside the vehicle or
near a south-facing window.
Make sure the antenna is correctly attached to
SKYFi2 and that the cable is not damaged or kinked.
Turn SKYFi2 off then on to reset this message.
Tune to another channel.
1-amp fuse only. If the 12V adaptor
does not have a removable end-cap,
it has an internal fuse that resets
itself after it is left unpowered for
a period of time.
To Next Page
Loading...
Need help?
General
