Revision April 2009 1-1
Chapter 1 Unpacking Check and Model Explanation
1.1 Unpacking Check
After receiving the AC servo drive, please check for the following:
îš„ Ensure that the product is what you have ordered.
Verify the part number indicated on the nameplate corresponds with the part number of your order
(Please refer to Section 1.2 for details about the model explanation).
îš„ Ensure that the servo motor shaft rotates freely.
Rotate the motor shaft by hand; a smooth rotation will indicate a good motor. However, a servo motor
with an electromagnetic brake can not be rotated manually.
îš„ Check for damage.
Inspect the unit to insure it was not damaged during shipment.
îš„ Check for loose screws.
Ensure that all necessary screws are tight and secure.
If any items are damaged or incorrect, please inform the distributor whom you purchased the product from or
your local Delta sales representative.
A complete and workable AC servo system should be including the following parts:
Part I : Delta standard supplied parts
(1) Servo drive
(2) Servo motor
(3) 5 PIN Terminal Block (for L1, L2, R, S, T) (available for 100W ~ 1.5kW models)
(4) 3 PIN Terminal Block (for U, V, W) (available for 100W ~ 1.5kW models)
(5) 3 PIN Terminal Block (for P, D, C) (available for 100W ~ 1.5kW models)
(6) One operating lever (for wire to terminal block insertion; available for 100W ~ 1.5kW models)
(7) One jumper bar (for short the circuit of the terminal pins; available for 2kW ~ 4.5kW models)
(8) Quick Start
Part II : Optional parts, not Delta standard supplied part (Refer to Appendix A)
(1) One power cable, which is used to connect servo motor and U, V, W terminals of servo drive. This
power cable is with one green grounding cable. Please connect the green grounding cable to the
ground terminal of the servo drive.
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
Need help?
General
