What should I do if the emergency stop is activated on my Delta Electronics Servo Drive?
If the emergency stop is activated on your Delta Electronics Servo Drive, it's because the emergency stop switch is disabled. Activate the emergency stop switch.
What causes regeneration error in Delta Electronics ASDA-A?
A regeneration error in Delta Electronics Servo Drives can occur due to several reasons. Check if the regenerative resistor is properly connected and reconnect it if necessary. If the regenerative switch transistor is faulty, return the unit to the distributor or manufacturer. A parameter setting error can also cause this, so correctly reset the parameters.
What causes an overspeed error on Delta Electronics ASDA-A?
An overspeed error on Delta Electronics Servo Drives can be triggered by a couple of things. First, the speed input command might not be stable, exhibiting too much fluctuation. To address this, ensure the input command frequency is stable and activate the filter function. Second, the over-speed parameter setting might be defective, so correctly set the over-speed parameter setting again.
What causes a serial communication error in Delta Electronics ASDA-A Servo Drives?
A serial communication error in Delta Electronics Servo Drives can stem from several issues. The communication parameter setting might not be correct, so ensure the parameter setting value is set correctly. Also, the communication address might be incorrect, so make sure the communication address is set correctly. Finally, the communication setting value might be incorrect, so verify that the communication setting value is correct.
What to do if my Delta Electronics Servo Drive shows an adjustment error?
If your Delta Electronics Servo Drive shows an adjustment error, it could be because the analog input contact does not correctly return to zero. Correctly ground the analog input contact. If the error persists after resetting the power supply, the detection device may be damaged, contact the distributor for assistance or return to manufacturer.
How do I resolve a forward limit switch error on my Delta Electronics Servo Drive?
A forward limit switch error on your Delta Electronics Servo Drive can occur if the forward limit switch is disabled, so activate it. It can also be caused by an unstable servo system, so modify the parameter setting and estimate motor capacity again.
What does it mean when my Delta Electronics Servo Drive displays 'excessive deviation'?
When your Delta Electronics Servo Drive displays 'excessive deviation', it indicates that the maximum deviation parameter setting is too small, so increase the setting value. It could also mean that the gain value is too small, so correctly adjust the gain value. Another possibility is that the torque limit is too low, so correctly adjust the torque limit value. Finally, there might be an overload, so reduce the external applied load or re-estimate the motor capacity.
How do I fix a reverse limit switch error on my Delta Electronics Servo Drive?
A reverse limit switch error on your Delta Electronics Servo Drive can be due to the reverse limit switch being disabled, so activate it. It can also happen if the servo system is not stable, so modify the parameter setting and estimate motor capacity again.
Why is my Delta Electronics Servo Drive showing an overvoltage error?
An overvoltage error on your Delta Electronics Servo Drive can occur if the main circuit voltage exceeds its maximum allowable value, or if there's an input power error due to incorrect power input. To resolve this, use the correct power supply or a serial stabilizer.
What causes a DSP communication error in Delta Electronics ASDA-A?
A DSP communication error in Delta Electronics Servo Drives is caused by a control power error. If the error does not clear after resetting the power supply, contact the distributor for assistance or return to manufacturer.
General| Series | ASDA-A |
|---|---|
| Category | Servo Drives |
| Control Modes | Position, Speed, Torque |
| Feedback | Incremental encoder, Absolute encoder |
| Protection Class | IP20 |
| Communication Interface | RS-485 |
| Protection Features | Over-voltage, Over-current, Overtemperature |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 65°C |
| Shock Resistance | 11ms |
To Next Page
