Delta Electronics ASDA-A Series

Other manuals for Delta Electronics ASDA-A Series

Questions and Answers:

Jennifer HoganAug 25, 2025

What causes an overspeed error on Delta Electronics ASDA-A?

G
Gary DavisAug 26, 2025
An overspeed error on Delta Electronics Servo Drives can be triggered by a couple of things. First, the speed input command might not be stable, exhibiting too much fluctuation. To address this, ensure the input command frequency is stable and activate the filter function. Second, the over-speed parameter setting might be defective, so correctly set the over-speed parameter setting again.

uleeAug 23, 2025

What causes regeneration error in Delta Electronics ASDA-A?

A
Austin ClayAug 25, 2025
A regeneration error in Delta Electronics Servo Drives can occur due to several reasons. Check if the regenerative resistor is properly connected and reconnect it if necessary. If the regenerative switch transistor is faulty, return the unit to the distributor or manufacturer. A parameter setting error can also cause this, so correctly reset the parameters.

Delta Electronics ASDA-A Series Specifications

General

Series	ASDA-A
Category	Servo Drives
Control Modes	Position, Speed, Torque
Feedback	Incremental encoder, Absolute encoder
Protection Class	IP20
Communication Interface	RS-485
Protection Features	Over-voltage, Over-current, Overtemperature
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 65°C
Shock Resistance	11ms