Chapter 7 Motion Control Functions
1. When writing data through the keypad:
Use P5-12 because P5-13 does not provide this function.
1) Set first address:
Set P5-11=11 (the first address)
2) Write data:
Set P5-12=100. (This is the first written data, 100th data and it will be saved in
address 11, i.e. P5-11. After write operation is completed, the address of P5-11 will
increase 1 automatically, i.e. address 12.)
Set P5-12=200 (This is the secondary written data, 200th data and it will be saved in
address 12, i.e. P5-11. After write operation is completed, the address of P5-11 will
increase 1 automatically, i.e. address 13.)
Set P5-12=300 (This is the third written data, 300th data and it will be saved in
address 13, i.e. P5-11. After write operation is completed, the address of P5-11 will
increase 1 automatically, i.e. address 14.)
Then, users can read the address 11, 12, and 13 and check the written values.
2. When reading data through the keypad:
Use P5-13 to read consecutive data.
1) Set first address:
Set P5-11=11 (the first address)
2) Read data:
When display shows P5-13:
Press SET key at the first time, the display will show the 100th data saved in address
11. Pressing MODE key can exit P5-13.
Press SET key at the second time, the display will show the 200th data saved in
address 12. Pressing MODE key can exit P5-13.
Press SET key at the first time, the display will show the 300th data saved in address
13. Pressing MODE key can exit P5-13.
Please note that when use P5-13 to read data every time, the address of P5-11 will
increase 1 automatically so using P5-13 can read the consecutive data. However, if
users use P5-12 to read the data, the address of P5-11 will remain the same, so using
P5-12 can not read the consecutive data.
7-10 Revision January 2011
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
