Delta Electronics ASDA-A2 Series - Page 456

Chapter 8 Servo Parameters
Revision January 2011 8-211
Setting value: 0x3A
DI Name DI Function Description
Trigger
Method
Control
Mode
EV2 Event trigger command 2 [see P5-98, P5-99]
Rising-edge/
Falling-edge
Triggered
PR
Setting value: 0x3B
DI Name DI Function Description
Trigger
Method
Control
Mode
EV3
Event trigger command 3 [see P5-98, P5-99]
(available in firmware version V1.009 and later
models)
Rising-edge/
Falling-edge
Triggered
PR
Setting value: 0x3C
DI Name DI Function Description
Trigger
Method
Control
Mode
EV4
Event trigger command 4 [see P5-98, P5-99]
(available in firmware version V1.009 and later
models)
Rising-edge/
Falling-edge
Triggered
PR
Setting value: 0x43, 0x44
DI Name DI Function Description
Trigger
Method
Control
Mode
GNUM0
GNUM1
Electronic gear ratio (Numerator) selection 0 ~ 1 [see
P2-60 ~ P2-62]
Level
Triggered
PT
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com