Delta Electronics ASDA-A2 Series - Page 513

Chapter 10 Troubleshooting
10-30 Revision January 2011
Display Fault Name Clearing Method
Error occurs when
reading CANopen PDO
object from EE-PROM.
NMT Maser send “Reset node“ command to
its slave or reset the fault by sending the
control word (0x6040) through CAN
communication (the value of CANopen object
0x6040 should be reset).
Error occurs when writing
CANopen PDO object into
EE-PROM.
NMT Maser send “Reset node“ command to
its slave or reset the fault by sending the
control word (0x6040) through CAN
communication (the value of CANopen object
0x6040 should be reset).
EE-PROM invalid address
range.
NMT Maser send “Reset node“ command to
its slave or reset the fault by sending the
control word (0x6040) through CAN
communication (the value of CANopen object
0x6040 should be reset).
EE-PROM checksum error.
NMT Maser send “Reset node“ command to
its slave or reset the fault by sending the
control word (0x6040) through CAN
communication (the value of CANopen object
0x6040 should be reset).
Password error
NMT Maser send “Reset node“ command to
its slave or reset the fault by sending the
control word (0x6040) through CAN
communication (the value of CANopen object
0x6040 should be reset).
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com