Chapter 1 Important Safety Instructions
1
Chapter 1 : Important Safety Instructions
1.1 Important Safety Notes
z
z
Only qualied personnel can service this equipment.
z
z
Follow the following precautions when working on this unit.
1. Remove watches, rings, or other metal objects.
2. Use tools with insulated handles.
3. Examine the packing container. Notify the carrier immediately if any damage
is present.
4. Do not disassemble the unit.
5. Do not operate the unit near water or in an area with excessive humidity.
6. Keep liquid and foreign objects from getting inside the unit.
7. Do not operate the unit close to gas or re.
z
z
Upstream circuit breaker must be added for each input. The recommended break-
er is D curve 30A for STS30002SR00035 and D curve 32A for STS30002SR10035
and STS30002SR10135.
z
z
Verify whether the branch circuit breaker or fuse on service feed is correct.
z
z
Verify line voltage requirements and the supplied line voltage prior to installation.
1.2 Electrical Warnings
z
z
When servicing this equipment, you will need to remove its protective covers and
disconnect the input power. Please observe great caution during these proce-
dures. Only qualied personnel can service this equipment.
z
z
Check that power cords, plugs, and outlets are in good condition.
To Next Page
Loading...
Need help?
General