4
ASSEMBLY
Make sure the saw is positioned for best balance and stability. All corners of the saw must be bolted securely to the
mounting brackets before use. Make sure no bolts extend above the saw table.
Note: Only 4 sets of securing hardware are provided with the stand. if this provided hardware does not work with your
saw, use hardware that will properly secure your saw.
1. Unplug saw and lock cutting head into down position.
Place the mounting brackets (B) on a stable fl at
surface.
2. Position the brackets (B) under the saw base holes.
Note: It may be more convenient to place the center of the
saw table on a block of wood, then position the mounting
brackets under the saw.
ATTACHING SAW TO MOUNTING BRACKETS
FOR INSTALLATION WHEN MOUNTING BRACKETS ALIGN WITH SAW MOUNTING HOLES
5
ASSEMBLY (continued)
3. Insert bolts (CC) through bracket and saw base. Place
washers (DD) on bolts and secure with nuts (BB).
FINGER TIGHTEN only. Repeat for other side.
4. Place saw and brackets (B) onto stand (D), hooking
front of mounting brackets on fi rst. Adjust to center
the table over the stand. Check to be sure that the
supports are in line with the table.
To Next Page
Loading...
