Chapter 11 Description of Parameter Settings|C200 Series
11-89
Bit0 Bit1 Bit2 Bit3 Bit4 Bit5 Bit6
Fault Code
current Volt. OL SYS FBK EXI CE
2: Over-current during deceleration (ocd) ●
3: Over-current during constant speed(ocn) ●
4: Ground fault (GFF) ●
5: IGBT short-circuit (occ) ●
6: Over-current at stop (ocS) ●
7: Over-voltage during acceleration (ovA) ●
8: Over-voltage during deceleration (ovd) ●
9: Over-voltage during constant speed (ovn) ●
10: Over-voltage at stop (ovS) ●
11: Low-voltage during acceleration (LvA) ●
12: Low-voltage during deceleration (Lvd) ●
13: Low-voltage during constant speed (Lvn) ●
14: Stop mid-low voltage (LvS ) ●
15: Phase loss protection (OrP) ●
16: IGBT over-heat (oH1) ●
17: Capacitance over-heat (oH2)
●
18: tH1o (TH1 open) ●
19: tH2o (TH2 open) ●
20: Reserved
21: Drive over-load (oL) ●
22: Electronics thermal relay 1 (EoL1) ●
23: Electronics thermal relay 2 (EoL2) ●
24: Motor PTC overheat (oH3) (PTC) ●
25: Reserved
26: Over-torque 1 (ot1) ●
27: Over-torque 2 (ot2) ●
28: Low current (uC) ●
29: Reserved
30: Memory write-in error (cF1) ●
31: Memory read-out error (cF2) ●
32: Reserved
33: U-phase current detection error (cd1) ●
34: V-phase current detection error (cd2) ●
35: W-phase current detection error (cd3) ●
36: Clamp current detection error (Hd0) ●
37: Over-current detection error (Hd1) ●
38: Over-voltage detection error (Hd2) ●
39: occ IGBT short circuit detection error (Hd3) ●
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
