Chapter 11 Description of Parameter Settings|C200 Series
11-126
Content Address Function
Bit 4-5
00B: No function
01B: FWD
10B: REV
11B: Change direction
Bit 6-7
00B: 1st accel/decel
01B: 2nd accel/decel
10B: 3rd accel/decel
11B: 4th accel/decel
Bit 8-11 000B: master speed
0001B: 1st accel/decel.
0010B: 2nd accel/decel
0011B: 3rd accel/decel
0100B: 4th accel/decel
0101B: 5th accel/decel
0110B: 6th accel/decel
0111B: 7th accel/decel
1000B: 8th accel/decel
1001B: 9th accel/decel
1010B: 10th accel/decel
1011B: 11th accel/decel
1100B: 12th accel/decel
1101B: 13th accel/decel
1110B: 14th accel/decel
1111B: 15th accel/decel
Bit 12 1: enable bit06-11 function
Bit 13~14 00B: No function
01B: operated by digital keypad
10B: operated by Pr.00-21 setting
11B: change operation source
Bit 15 Reserved
2001H Frequency command
Bit 0 1: EF (external fault) on
Bit 1 1: Reset
Bit 2 1: B.B. ON
Command
Write only
2002H
Bit 3-15 Reserved
Status monitor
Read only
2100H
Error code: refer to Pr.06-17 to Pr.06-22
2101H Bit0
Bit1
AC Drive Operation Status
00b: Drive stops
01b: Drive decelerating
10b: Drive standby
11b: Drive operating
Bit2 1: JOG Command
Bit3
Bit4
Operation Direction
00b: FWD run
01b: from REV run to FWD run
10b: REV run
11b: from FWD run to REV run
Bit8
1: Master frequency controlled by communication
interface
Bit9 1: Master frequency controlled by analog signal
Bit10
1: Operation command controlled by
communication interface
Bit11 1: Parameter locked
Bit12 1: Enable to copy parameters from keypad
Bit13~15 Reserved
2102H Frequency command (F)
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
